| |
Directions: Step
1: Wash your face with a mild cleanser.
Step 2: After vigorously shaking your bottle of Strivectin-HS for
approximately 10 seconds, dispense 6-8
drops into the palm of your hand.
Step 3: Apply Strivectin-HS with your fingertips directly to the most
pronounced at the corners of the eye,
between the brow, around the lips and down the nasalabial folds (the deep
lines that run from the
edge of your nose to the corners of your mouth). Wait 1-3 minutes or until
serum becomes dry and
slightly tacky to the touch.
Step 4: Soak a clean facecloth in hot (not scalding) water (wring out excess
water) and hold it firmly to your
face for 60 seconds or until the towel cools.
Step 5: Remove the towel and pat your face dry.
NOTE: Use
Strivectin-HS twice daily until desired results are achieved. Then use three
times per week to maintain
results.
Ingredients: Glycerin,
Sodium Polystyrene Sulfonate, Yeast Extract (Faex), Dipeptide Diaminobutroyl
Benzylamide
Diacetate, Acrylates/C10-30 Alkyl Acrylate Crosspolymer, Tetrasodium EDTA,
Phenoxyethanol/
Methylparaben/ Ethylparaben/ Butylparaben/ Isobutylparaben/ Propylparaben,
Potassium Chloride,
Albumen, PEG-12 Dimethicone, Polypeptide-153, hydrolyzed Soy Protein,
Butylene Glycol, Water(Aqua),
Xanthan Gum, PEG-8, Arginine, Glycereth-26
Storage Instructions: Store at a controlled room temperature of
15-30°C/59°-86°F
Warning: For external use only. Use only as directed.
Before using Strivectin-HS on a regular basis, test on a small area of your
forearm. If extreme redness/rash or itching occurs, discontinue use. Avoid
direct contact with eyes, flush with warm water. Not for use by indviduals
under 18 years of age unless directed by a doctor.
Keep out of reach of children. |
